Svapo Planet - Strada Beneceto 58 - 43122 Parma - Cell: 320 8735700
Joyetech Exceed EX-M Head Coil di ricambio per Exceed Grip POD...
Speed Revolution 2019 Luca Creations.
Augvape Merlin Nano MTL RTA da 18mm con beauty ring da 22ml
Dovpo Nickel 230w Box Mod a 2 Batterie 18650 non comprese nella confezione.
DEJAVU - DJV D7 180W Touch Screen TC Box MOD
Joyetech Exceed Grip POD di ricambio usa e getta da 3,5 ml.
Wotofo Recurve Dual RDA 24mm.
Eleaf iJust 2/S - Melo 2/3/4/5 mesh Coil Head di ricambio da 0.6 ohm in...
Eleaf Kit istick Rim solo Box. Ricarica veloce USB Type-C. Batterie...
Gate MTL RTA da 22mm e 2ml di contenuto by Ambition Mods
SmokTech TFV8 Baby da 22mm.
Versione TPD da 2ml.
Attenzione: Ultimi articoli in magazzino!
TFV8 Baby, which size is 1/3 smaller than the Cloud Beast - TFV8. Meanwhile, its airflow system: the bottom pair air-slots, the air chamber, the drip tip, are re-designed after precise calculations and optimizations. All those efforts ensure that TFV8 Baby is another Cloud Beast - a Baby Beast.
TFV8 Big Baby is the enlarged version based on TFV8 Baby, both its 5ml e-juice capacity and more vapors will let you enjoy pleasant vaping time.
Two editions, two experiences for you.
TFV8(24.5*69mm) VS TFV8 BIG BABY VS TFV8 Baby(22*53mm)
Re-designed bottom pair air-slots, air chamber and drip tip provide you with powerful draw effects.
Bring you an extremely open draw. Airflow can be adjusted freely by turning the ring at the base of atomizer.
Top refill system makes filling as easy as it gets.
Leak proof e-liquid slot can significantly solve leaking problem.
1. Before starting make sure your hands are clean.
2. Taking RBA deck apart.
3. Installing and positioning the pre-wrapped coil. Place the coil between the posts and wrap the ends around the screws and tighten up, once all in place make sure the coil is fixed in the center and lined up with the air hole, and also make sure the coil is NOT touching the base.
4. Cutting the ends of wire off.
5. Cutting a strip of cotton and make sure it’s not too much and not too less.
6. Inserting the cotton, and placing it in the middle.
7. Cutting the cotton at an angle and make sure it’s not too short and not too long.
8. Wet the coil with your e-liquid and adjust the cotton.
Warning: Coils must be checked for resistance before they are fired on a device, and re-checked periodically toensure the resistance remains the same.